Maintenance Method of Wire Bending Machine

The wire bending machine is mainly used for laying and repairing pipelines in construction and decoration. It has the advantages of multiple functions, reasonable structure, and simple operation. The oil cylinder can also be used as a hydraulic jack, which is easy to use and occupies the leading product position in the domestic wire bending machine market.

Today we come to understand the maintenance method of the wire bending machine.

1. Check the surrounding area of the work site and remove all debris that hinders work and traffic. There should be no oil stains on the ground to avoid slipping. The workpieces should be stacked neatly and firmly to prevent them from collapsing and hurting people.

2. Check whether the protective device on the bending machine is intact. If it is not installed, it is not allowed to drive. The intermediate frequency pipe bender should have good grounding and electrical insulation, and the voltage should be stable.

3. Check the lubrication parts of the wire bending machine, and add enough oil when there is oil shortage or no oil.

4. During the empty test run, check whether the machinery is running normally and whether the electrical switches are sensitive and easy to use. After everything is normal, proceed to work.

5. When two people are working at the same time, they must cooperate closely and coordinately. A dedicated person should be assigned to operate the switch. Do not talk or laugh with others during operation to prevent misoperation.

6. The operator shall not leave the machine tool when the machine tool is running.

7. When the wire bending machine is working, no people are allowed to be near the bending stroke range of the pipe, and a protective warning sign is set up. Stand firm when prying the pipe to prevent being injured by the pry bar slipping. The operator can only stand on the outside.

8. To calibrate the pipe, pay attention to the safety around it, and immerse the hammer in the water first; a few minutes to prevent the handle from being removed and hurting people. It is forbidden to wear gloves when knocking on the tube.

9. When hot bending and correcting the tube, the face should avoid the nozzle to prevent the hot sand from spraying out and hurting people when the tube is shaken. When filling yellow sand, the pipe should be hung firmly to prevent it from tipping. There should be no greasy dirt in the pipe, and dry yellow sand should be used.

10. When the strapping pipe is put into the rack and the strapping lead wire is untied, it must be blocked and cushioned to prevent rolling and crushing injuries. Pay attention to pedestrians when handling pipes to prevent bruising.

11. When using gas, open the furnace door first, blow off the excess gas, and then ignite.

After understanding some of the basic wire bending machine maintenance methods above, if you still have some questions, please contact Quanjiu Machine for consultation.