Operating procedures of wire cutting machine

Views: 453 Author: Site Editor Publish Time: Origin: Site

1. Preparation before cutting

(1) The performance of the equipment must be carefully checked before use to ensure the integrity of all components.

 

(2) The power switch, the tightness of the saw blade, the saw blade guard or the safety baffle should be inspected in detail. The operating table must be stable and there should be sufficient lighting during night operation.

 

(3) Before use, turn on the main switch first, test it for a few times without load, and allow it to start after confirming that it is safe and correct.

 

(4) Before operation, you must check whether the power supply is consistent with the conventional rated 220VA voltage on the power tool, so as not to connect it to the 380VA power supply by mistake.

 

2. Cutting precautions

(1) When the wire cutting machine is working, you must be fully focused, not only to keep a clear mind, but also to operate the power tool rationally. It is strictly forbidden to operate the cutting machine after being tired, drinking or taking stimulants or drugs.

wire cutting machine

(2) The power line must be safe and reliable. It is strictly forbidden to pull it without authorization. The power line must be placed carefully and not cut off. The performance of the equipment must be carefully checked before use to ensure that all parts are in good condition.

 

(3) Wear suitable work clothes, do not wear loose work clothes, and do not wear jewelry or long hair. It is strictly forbidden to wear gloves and operate without cuffs.

 

(4) The processed work piece must be clamped firmly, and it is strictly forbidden to start cutting when the work piece is not clamped tightly.

 

(5) It is strictly forbidden to grind the burrs of the work piece on the surface of the grinding wheel to prevent the grinding wheel from chipping.

 

(6) When cutting, the operator must deviate from the front of the grinding wheel and wear protective glasses.

 

(7) It is strictly forbidden to use the incomplete grinding wheel, prevent sparks from splashing when cutting, and keep away from flammable and explosive materials.

 

(8) When clamping the work piece, the clamping should be stable and firm, and the protective cover must be installed correctly. After clamping, the machine should be turned on and run dry to check.


(9) When replacing a new cutting blade or grinding wheel in the middle, do not use too much force on the lock nut to prevent the saw blade or grinding wheel from cracking and accidents.

wire cutting machine 

(10) It is necessary to hold the handle of the cutting machine firmly and evenly and forcefully cut vertically, and the fixed end must be firm and reliable.

 

(11) If there is any abnormal sound, the inspection should be stopped immediately; the power supply must be cut off before maintenance or replacement of parts, and the saw blade should stop completely.

 

(12) When using a wire cutting machine to work in a damp place, you must stand on an insulating pad or a dry wooden board. Safety precautions must be taken when climbing or using in hazardous areas such as explosion-proof.

 

(13) After processing, the power supply should be turned off, and the equipment and surrounding areas should be cleaned.

 

 


×

Contact Us

captcha